1. Check air handler filters, and clean or replace as necessary.
2. Check for adequate refrigerant charge and add if necessary.
3. Check condenser fan blades for tightness.
4. Tighten electrical connections at the equipment.
5. Check condenser and clean if necessary.
6. Check voltage at unit under load.
7. Check condensate under drain for blockage. Clean as necessary.
8. Lubricate all bearings where applicable.
9. Check blower for cleanliness and clean if necessary.
10. Make recommendations for any needed repairs to the system.
11. Check all safety controls and inspect contactor points, evaporator coils, starting capacitor, running capacitor, and relays.
12. Check for vibration and noise.
13. Check pressures.
14. Check blower belt and replace if necessary.
    

*** This preventative service should be scheduled during normal working hours, Monday-Friday 8:00am to 5:00pm. If you would like to request a service time, please call . ***

The standard preventative maintenance agreement provides basic coverage for the parts of your heating system that need frequent service. This means any parts listed below will be covered at a 20% discount if they need to be replaced. This agreement includes a thorough pre-season inspection to ensure peak performance of your system. Please refer to the following list for specific parts coverage under your agreement.

•  Low-Pressure Switch
• Condenser Fan Blade
• Blower Belt
• Running Capacitor
• Crankcase Heater
• Air Handler Circuit Board
• High Pressure Control
• Contactor
• Time Delay Relay
• Starting Capacitor
• Non-Digital Thermostat
• Fan Relay
• Metering Device
• Blower Control
• Transformer
• Condenser Motor
• Blower Motor
• Refrigerant, 2lb max

Any parts not listed above, and labor associated with their replacement, will be billed at the prevailing parts and labor rates. Environmental disposal fee is included as a covered item under the agreement as it relates to covered parts; items replaced that are not covered may be subject to this fee.